Ultimate all surface paint with up to 15 years performance, available in Anthracite Grey and recommended for use on uPVC and composite windows and doors.
Zinsser AllCoat Exterior Satin (Solvent Based) Anthracite Grey RAL7016 is an ultimate performance all surface paint. Designed for the long-term decoration (up to 15 years) of timber, metal, masonry, plastic, concrete, cladding and more. It forms a low maintenance water-shedding coating, re-coatable in 3 hours. Zinsser AllCoat Exterior Satin (Solvent Based) contains a biocide to protect the dried coating against fungal degradation. Available in 4,100+ RAL, NCS and BS colours.
Designed for all paintable exterior surfaces, it is ideal for low temperature applications where water based may not be suitable on new or previously painted wood, uPVC, galvanising, steel, aluminium, cladding, stucco, brick, stone, cured concrete, Plastisol and more. Zinsser AllCoat Exterior Satin (Solvent Based)answers the question "can you paint upvc windows and doors?"
This product is not suitable for application on floors.
Recommended Uses
Surfaces must be clean, sound and free of dirt, dust, grease, wax, loose paint or other surface contamination. Remove all existing mould and mildew before painting.
To effectively remove mould and mildew, use Blackfriar Fungicidal Wash. Timber at risk from decay or insect attack should be treated with Blackfriar Exterior Wood Preservative Gold Star Clear.
Very hard or glossy previously painted surfaces should be abraded and degreased. Before painting, fill all nail holes and gouges. Where necessary, spot prime knots and sap streaks with Zinsser B-I-N Primer-Sealer.
Abrade & degrease unweathered plastisol & powder coatings.
Allow new plaster/cement & stucco to cure 60-90 days before coating.
Thoroughly degrease new galvanised steel.
WARNING! If you scrape, sand, or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE.
For Composite Surfaces;
Always ensure that the surface has been prepared sufficiently, Zinsser Universal Degreaser & Cleaner is ideal for this. As composite surfaces tend to have a wax like finish we would also advise lightly abrading the surface area. Two coats are required, the first coat acts as the primer and the second seals and protects the system
Stir well before using.
Apply when air and surface temperatures are between 5℃ and 32℃ and humidity is less than 80%.
For airless spray use tip 0.13 - 0.017 at pressure 1800 – 2400 psi.
Normal application is 2 coats, however an additional coat should be applied to areas of high exposure such as sills and fascia boards.
At normal temperatures i.e. 20℃, ALLCOAT Exterior Satin (Solvent Based) dries to recoat in 3 hour. Full cure takes 7 days.
Up to 10m2 per litre.
Normal application is 2 coats, however an additional coat should be applied to areas of high exposure such as sills and fascia boards.
Clean up application tools, spills and drips with a white spirit.
If product has dried on application tool, clean with Zinsser Brush Cleaner and restorer. Follow manufacturer’s instructions when cleaning spray equipment.
Dispose of unused or unwanted product in accordance with local laws regulating solvent-based coatings.
ALLCOAT® Exterior Satin (Solvent Based) is not intended for application to exterior floors or decks or any surface subject to water immersion.
To prevent product from skinning over, close container after each use. Keep lid tightly closed during storage.
The paint film is designed to resist cracking, peeling and blistering for up to 15 years before first maintenance. The contents are warranted to be free of defects for two years from date of manufacture.
All warranties and guarantees are limited to replacement or refund value of product actually used when supported by proof of purchase.
Directions are as complete as possible but cannot encompass all conditions, applications and / or surfaces beyond our control.
If you have a question, please contact Zinsser or Rawlins Technical Support on 0113 2455450 (option 2) or send a message to [email protected].
| Product Data | |
|---|---|
| Product Reference (gloss level) | ZN740 |
| Drying | Touch dry 1 hour, hard dry 16 hours at 20℃. |
| Full cure achieved after 7 days. | |
| Recoat | 3 hour at 20℃ |
| Note | Drying and recoat times will be extended at a lower temperature. |
| Spread Rate | 10m2 per litre per coat. |
| Gloss Level | 20% |
| Volume Solids | 50% |
| Typical film thickness per coat | 50 microns dry from 100 microns wet. |
| VOC | (cat. A(i), limit 500g/lt) <500g/l |
| Shelf life | 2 years in unopened containers |
| Method of Application | Brush, Roller or Spray |
| Thinner | Not normally required (use white spirit for conventional spray - not more than 10%). |
| Cleaner | White spirits for cleaning equipment. |
Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.
 Ellen on 2024-01-31 09:28:53 | Question: Can this be used to paint my outdoor window frames? What will I need to do in prep? |
Answer from Rawlins’ Technical Team: Assuming the window frames are UPVC, that are clean, dry, sound, lightly abraded and prepared as detailed in the technical datasheet, this product can be applied in 2 coats to treat the window frames, the first coat will prime and the finish coat will seal and protect. | |
| Jessica on 2023-04-16 17:12:19 | Question: Hi I am wanting to use this paint to paint my outdoor concrete window ceils would this paint be appropriate? |
Answer from Rawlins’ Technical Team: Yes this product could be used, we would recommend to apply three coats to areas that could be exposed to pooling water. If the window sills are previously painted we would recommend to test on a small area for compatibility and adhesion prior to full application. | |
| Amy on 2023-02-09 10:14:02 | Question: I have a new concrete retaining wall in my garden which I would like to paint anthracite grey. Will this paint work for that and do I need to prime the wall first? |
Answer from Rawlins’ Technical Team: Unforuntately this product would not be suitable for painting a retaining wall as the normally hold moisture which will cause the paint to fail. Assuming the retaining wall is clean, dry, sound and prepared as detailed in the technical data sheet we can recommend Zinsser Watertite. This is available in white and a range of pastel shades. | |
| Jillian Hunter on 2022-10-24 19:44:53 | Question: What is the area covered per litre? |
Answer from Rawlins’ Technical Team: The coverage rate for this product is 10m² per litre per coat. Preparation and application information is in the technical data sheet, this can be found in the data sheets tab on the product page. | |
| Diane kelly on 2021-11-29 21:00:23 | Question: Can I go over satin allcoat exterior with Matt as don’t like the shine |
Answer from Rawlins’ Technical Team: Yes once the previously applied paint is fully cured, it is clean, dry, sound and prepared as detailed in the technical data sheet it could be over painted with Zinsser Allcoat Exterior Matt (Water based). A matt finish is only available in the water based version, we would not recommend applying water based at this time of year due and it would be best to wait till spring. It may be worth noting as the applied satin paint weathers the shine will reduce, which may end up being a finish you will be happy with. | |
| Daniel Mortimer on 2021-11-05 10:41:41 | Question: I want to paint a garage door, using an electric fence sprayer will it have to be thinned down with thinners? If so what is the percentage? Or can I use it straight out of the tub? |
Answer from Rawlins’ Technical Team: This product does not normally require to be thinned for application by brush, roller or airless spray, but can be thinned to a maximum of 10% with white spirit for conventional spray application. We would recommend consulting the manufacturer of the electric fench sprayer to see if it is capable of spraying this paint. | |
| Mrs Michelle Kilpatrick on 2021-09-15 16:49:32 | Question: Can this product be used indoors? I am wanting to paint a wooden headboard. Regards |
Answer from Rawlins’ Technical Team: This product can be used indoors, but the Zinsser Allcoat Exterior (water based) would be a better option as it will have less odours. | |
Zinsser AllCoat Exterior Satin (Solvent Based) - Anthracite Grey is only available with the shipping and delivery timescales listed below - please do not contact our Customer Support Team with enquiries about alternative or earlier shipping and delivery times.
Saturdays and Sundays, as well as Bank Holidays, are not classed as working days.
Orders placed after the cut-off for this product will not be processed for earliest dispatch until 9am the next working day.
All delivery costs below are excluding VAT
Great for priming interior surfaces and spot priming exterior surfaces, formulated to seal, prime and block out stains on previously painted or new work and dries in minutes. For interior and spot exterior use Highly effective stain sealer Seals knots and sap streaks Permanently blocks odours Adheres to surfaces without sanding Dries...
£17.83 (incl. VAT)
£14.86 (ex. VAT)
The ultimate performance shellac-based primer-sealer and stain killer in 1,500+ colours for interior and spot exterior use. Offers unparalleled adhesion to glossy surfaces (including glass) without the need for scuff sanding and blocks stubborn and persistent stains.Permanently blocks odours Unparalleled adhesion to any surface without...
£31.93 (incl. VAT)
£26.61 (ex. VAT)
General Painting Application Kit from Rawlins Paints provides the basics for any painting project. Whether it is a one off job, or you just want to make sure the right application tools get to site.Provides an economical way of making sure you will have what you need Ideal for interior and exterior paint projects Click to jump down to...
£12.04 (incl. VAT)
£10.03 (ex. VAT)
Zinsser Brush Cleaner & Restorer renews and restores used and hardened brushes in just 4 hours. It removes Zinsser B-I-N and most types of dried-on paint easily, is fast acting and does not require overnight soaking. More Information Delivery Info
£8.40 (incl. VAT)
£7.00 (ex. VAT)
Zinsser Mould Killer and Remover is for use against fungi, moulds and algae on internal surfaces such as tiles, wood, plaster, and wallpaper. Zinsser Mould Killer and Remover is water based and ready for use.Kills and removes fungi, mould and algae growth Powerful fast acting formula Suitable for all interior surfaces Removes mould...
£8.40 (incl. VAT)
£7.00 (ex. VAT)
