Assuming the substrate is previously painted, and is prepared as detailed in the technical datasheet, this product will be fine for application.

It is developed with optilife silicone technology to provide long term protection and piece of mind, allowing the substrate to be highly breathable and self cleaning, whilst being ultra waterproof and algae resistant.

If the existing substrate is affected currently by bacterial, algae or fungal growth, we'd recommended this should be treated with Wethertex C10 Multi-Surface Fungicidal Wash prior to use.

We advise to test on a small area for compatibility and adhesion prior to full application.

Assuming the substrate is prepared as detailed in the application instructions, this product is suitable for application over most existing coatings, with 2 coats recommended.

We'd suggest applying to a small test area firstly to ensure compatibility.

Assuming you have suitably cleaned and degreased the substrate in accordance with the technical datasheet and the surface is dry prior to applciation, this product will be fine, however the system could be prone to cracking due to a thin film.

We'd recommend filling the joints with an acrylic mastic, applying a scrim tape over the joints prior to application of 3 coats of Wethertex AP77 Flexible Smooth Masonry Paint with the first coat thinned 10% with clean water. 

This can be mixed to many RAL, NCS or BS colours in a matt finish.

The coverage rate for this product is 4 to 15m² per litre per coat. 

On new cement based render assuming it is smooth you could expect to acheive approximately 6 to 8m² per litre for the first coat and 10 to 12m² with the second.

This product isn't suitable for use on Lime Render substrates.

Assuming the lime render is clean, dry and sound we can recommend 2 coats of Keim Soldalit-ME, with a coat of Keim Soldalit Fixativ onto any bare areas first.

Two coats are recommended.

You should allow 2 to 4 hours between coats.

Unfortunately many of the manufacturers do not produce samples, but Keim Colour Samples or Graphenstone Samples are available along with Colour Sample Sachets in a generic paint to aid choosing a suitable RAL, NCS or BS colour.

Unfortunately no, a masonry paint would not be suitable for this application.

Assuming the concrete pond walls are bare, they are clean, dry, sound and prepared as detailed in the technical data sheet we can recommend Teamac Chlorvar Chlorinated Rubber Paint.

The bare concrete must be treated prior to application with Coo-Var Acid Etch.

The first coat of paint must be thinned 10% with Teamac Thinner 15 then 2 further coats applied unthinned.

This is available in many RAL, NCS or BS colours in a gloss finish.

 Please note the pond must be left 14 days prior to refilling.

No, unfortunately we do not have a masonry paint suitable for this application.

No, for application to timber assuming it is clean, dry, sound and prepared as detailed in the technical data sheet we can recommend Wethertex OT25 Wood-Flex Satin Opaque Timber Paint.

This is available in many RAL, NCS or BS colours in a matt finish.

No this should be used externally, you could consider Wethertex MS11 Multi-Surface Renovation Paint.

This can be used internally or externally on many substrates.

This can be mixed to many RAL, NCS of BS colours in a satin finish.

Two coats would be recommended when applied to a clean, dry, sound previously painted substrate prepared as detailed in the technical data sheet.

The walls should be washed prior to application and Wethertex C10 Multi-Surface Fungicidal Wash used to remove any algal or fungal growth.